u bolts
Posted: Mon Jul 12, 2004 6:33 pm
ok, so iv done my SO, rotated the nuckles, now my front right u bolt (next to the 3rd member) wont fit, are there any suggestions? or do i just try to bend one...
James
Page 1 of 1
Posted: Mon Jul 12, 2004 10:00 pm
Yeah, you need to bend it to get it to fit.
James
James
Posted: Tue Jul 13, 2004 10:20 am
same thing same place happened to be. go to it with that thing that puts that hot stuff out the nozzle thingy. o and then bend it.
o and then bend it.Posted: Tue Jul 13, 2004 12:24 pm
cold bend it with a vice.
are you using the u bolts that rap around the axle tube or the other type that go on the bracket that goes on the axle tube? (see glen1n rolls it thread)
are you using the u bolts that rap around the axle tube or the other type that go on the bracket that goes on the axle tube? (see glen1n rolls it thread)
Posted: Tue Jul 13, 2004 2:57 pm
hmm yeh i had a bit of a try at putin it in the vice an hittin it with a hammer, but my vice isnt bolted down strongly enough 
oh well ill get it. cheers.
oh well ill get it. cheers.