Outer Limits 4x4 Board

Does anyone know if MQ knuckles will fit on a GU diff?

Nup, same size as gq. Still chasing the high steer?

Yeah, the only one I can find is the one made by rdg engineering and that only lifts the drag link and panhard it doesn't move the tie rod so it's no good to me.

Do the gq nuckles fit on gq? I have mq Nuckles on my gq diff and they work great

Has anyone done a high steer on a GU?

I have sort of but not for a road going one. You'll prob have to go to an engineering shop n get one made up custom.

Yeah I think I am going to have make my own, don't really have the time tho thats why I was trying to buy one

Anybody having any luck with high steer set up ?

Marshal at All Barred Up Customs in Oak flats has made a custom weld on setup for his GU diffed GQ and it puts the two arms up high and in front of the diff. Looks good. Maybe look him up and give him a call

I swapped my swivel housings left to right to get the tie rod out front on my GQ diff, might work the same on a GU.

MILLSY wrote:I swapped my swivel housings left to right to get the tie rod out front on my GQ diff, might work the same on a GU.

How was the clearance between the panhard and steering arm ?
Do you have any pictures you could put up of your steering arrangement ?
And did you cut off the old steer mount off the knuckle ?

Clearance was very tight, but it worked. I'll try to chase up some pics. Is this for the road or a comp truck. You chasing high steer or clearance for a five link.

Will be driven on road to tracks on weekends but only a few kms.
Will be putting a custom link set up in further down the track.
Just hate the idea of the drag link hang down there.

MILLSY wrote:I swapped my swivel housings left to right to get the tie rod out front on my GQ diff, might work the same on a GU.

ON a GU I think the arms are lower, so tie rod sits pretty low. If you were going hydro steer the ram would be mounted below the axle tube out the front, so not ideal.

joshy wrote:I have sort of but not for a road going one. You'll prob have to go to an engineering shop n get one made up custom.

Hey Joshy I'm interested in what you have done, sent you a PM.

Do GQ leafy knuckels just bolt on to GQ coil housing or is there more in it then just bolting on ?