Outer Limits 4x4 Board

Ive got a 96 GQ wagon and am in the process of fixing up a few little problems. One in particular thats annoying me is the air vent control lever wont fully slide along to the windscreen position.
I jammed my head up under the dash and you can see the control mechanism easily, disconnected the cable and it gets full stroke and moves to each position smoothly. But with the cable connected it only goes to the middle roughly...... It seems the cable is the wrong length. I didnt think there would be different length cables?
Anyone ever had this problem?

more likely there is something jamming the flap and restricting movement.
Maybe a pen left on the dash and worked its way down through the vent?

Check that the cable is not kinked.

also there is a little clip that holds the tube the cable runs in.. they often come off or the tube slips inside the clip.

The flap moves freely when the cables disconnected, but with it connected it only has half travel. The cable itself doesnt seem long enough.....is it possible to connect the lever in a different position or something silly like that?

Betcha the wire is kinked at the control lever end.
Time for a new cable.

i've got the problem at the other end so i cant get onto face only. after i while i worked out i can reach plastic control down by your calf while still driving and get the last bit out of it so i can get face only

MikeH wrote:Betcha the wire is kinked at the control lever end.
Time for a new cable.

I reckon you may be onto something, that would make sense. Will check it out soon. Thanks mate.

nayto wrote:

MikeH wrote:Betcha the wire is kinked at the control lever end.
Time for a new cable.

I reckon you may be onto something, that would make sense. Will check it out soon. Thanks mate.

Yeah. That is where they bend.