Page 1 of 1
351 clevland to 302 cl questions...
Posted: Mon May 14, 2012 8:23 pm
by ndog
hi guys ive got a 40 series i roled last last year its got a 351 c in it i got a bent rod and havea 302 c to put in im pritty sure its got same engine mounts , does any 1 know if the carbies and water pumps fit in both? and how hard the swap will be? cheers nathan.
Re: 351 clevland to 302 cl questions...
Posted: Mon May 14, 2012 9:14 pm
by GUtripper
Blocks are same, heads should be same ( internally diff between 2v and 4v).
Bore/stroke is internal difference obviously. A greater chance the 351 has a 4 bbl intake and carb, most(all?) factory 302's were 2 barrel?
Not sure on water pumps etc, may vary between models, ie xa - xe perhaps, as may position and brackets for ancillaries.
I swapped a 302 c with a turned bearing for a 351 c out of same vintage, (xb) straight bolt in.
Re: 351 clevland to 302 cl questions...
Posted: Tue May 15, 2012 7:38 pm
by want33s
302 & 351 Cleveland blocks are externally identical.
Water pumps, manifolds, fuel pump etc etc are all interchangable.
Swapping it in will be a piece of cake.
(The distributor is about the only possible difference. Up to 1979 clevo's were painted blue, these use a half inch distributor shaft.
Post 1980 they were painted black and use a 12mm distributor shaft.)
If I were you I'd be looking for a new set of 351 rods.
Re: 351 clevland to 302 cl questions...
Posted: Tue May 15, 2012 9:19 pm
by ndog
so whats the better motor?
pritty sure the 351 is a xb motor needed a tune befor i roled it so dont really know how it was just need to get it running for now anything will help , have open ears
cheers guys
Re: 351 clevland to 302 cl questions...
Posted: Tue May 15, 2012 9:50 pm
by Red04VXE
Buy new pistons and rebuild the 51 with the 02 Conrods
Re: 351 clevland to 302 cl questions...
Posted: Wed May 16, 2012 9:30 am
by want33s
Red04VXE wrote:Buy new pistons and rebuild the 51 with the 02 Conrods
I was going to suggest that but thought it might be beyond the OP's capabilities if he's asking about swapping.
351 crank + 302 rods + pistons to suit = Good power and a very flat torque curve.
Re: 351 clevland to 302 cl questions...
Posted: Wed May 16, 2012 5:11 pm
by ndog
yer bit to much work for now plus havernt really done to much rebuilds and internal work yet so might wait till i got more time for that