Outer Limits 4x4 Board

Okay my brake holds fine on hills its when it's not in use that's the problem the cable slowly gets loose over a few days of regular driving. Is this common? Also my brake has started to stick when trying to free spool. I'm assuming these problems are related but seem far apart. Could it be the diesel ratteling it loose ?

I doubt it would be diesel "rattle" causing it to unwind, more like the brake slipping. When was the last time it was pulled apart and serviced.

Oil was done 6 months ago but that's it. What's involved in serviceing the brake ?

Are the brake ball bearings ment to be greesed or run dry ?

Bearings run dry.

You need to disassemble the brake set, replace the brake discs and the brake will hold again.

Sticking on free spool is caused by the brake spring being worn and not forcing the brake components apart enough.

http://www.youtube.com/watch?v=WXLnAqgRpFE" onclick="window.open(this.href);return false;

http://www.youtube.com/watch?v=AetCZJxvNdU" onclick="window.open(this.href);return false;

The bearings had been greesed which had worked its way out to the pads. Spring was working okay but the centre of the brake was sticking to the winch side still. Have cleaned it all and will try get it back togeather temporarally till I get the new discs. Thanks heaps for the videos mate.

Dose any one know if I can just buy the discs or do I have to get a kit? Also should I scuff up the plates with some fine sand paper while there out ?

I can supply you after market Gigglepin Brake Shoes, $70 per set

Smithiengineering is the place to go for winch gear. As for scuffing up the plate.. personally i actually grease my brake discs up but i use a gigglepin brake shaft.

cheers Smitty

Dose it still hold okay mate. ?