Page 1 of 1
vortex, rockert power mufflers
Posted: Sun Jul 25, 2004 1:11 pm
by uninformed
hey all, i'm woundering if anyone has herd about these/or used them. you can check them out at
www.nutech2000.com/prod10.htm i have a 2.5 tdi defender and need to replace the muffler, so was thinking of upgrading at the same time. after doing a search it seems that the general go is to run a straight through 2.5-3 inch mandrel bent with no muffler. is this legal(no muffler) any thoughts word be great
cheers, serg
Posted: Sun Jul 25, 2004 2:42 pm
by Hybrid
Its not legal to run no muffler. It would be above noise pollution regs.
Posted: Sun Jul 25, 2004 6:46 pm
by bazzle
Just run a staight thru pipe with a straight thru 15" resonator to take away drone and excess noise.
Bazzle
Posted: Mon Jul 26, 2004 8:17 am
by murcod
Some of those testimonials are a worry eg the unleaded VN Commodore that had the exhaust tip colour change from black to grey.... unleaded cars are supposed to be black!
I think I've seen the same mufflers fitted to a friends F100 V8. We were all dubious, but IIRC it did actually improve on the dyno. The exhaust sound was something else too with a distinct whistle at high revs.
Posted: Mon Jul 26, 2004 8:46 am
by mattc
Test of that muffler - didn't do anything in their (A Current Affair) tests on an 01 AU Falcon
http://aca.ninemsn.com.au/stories/750.asp
Posted: Mon Jul 26, 2004 1:07 pm
by murcod
I guess it would depend what the "before" muffler was!
That test was purely measuring emissions and fuel economy too- nothing mentioned about power output.
Posted: Mon Jul 26, 2004 1:13 pm
by bogged
What about one of them Galvanized Garbage Can exhaust tips? They any good?
This type take the lid off aim out the back, and your instantly Gino, or Big Dik Suk.... take your choice.
Posted: Mon Jul 26, 2004 1:33 pm
by 1MadEngineer
Posted: Mon Jul 26, 2004 2:49 pm
by murcod
1MadEngineer wrote:http://www.flowmastermufflers.com/
THE BEST!
Yes, I was thinking about putting one of them on the Feroza. What sort of price do they go for?
Posted: Mon Jul 26, 2004 4:18 pm
by 1MadEngineer
flowmasters arent cheap or really a bling chromed bit of tin but they are 1.6mm aluminized steel fully mig welded, way better than a rolled edged piece of tin packed with fibreglass. They out perform and out last all the others, generally only see them on high HP drag and speedway engines in OZ but they sound FAT on a street car. A little loud at idle but really shut up the noise when your up it! A lot of cars in 'petersons 4x4' run them.
I have dynoed prob 20 cars with them fitted and they gave awesome results in all applications. average price about $200-$275 (street application)
Posted: Tue Jul 27, 2004 1:10 am
by ISUZUROVER
Have a look at the rest of the rubbish you can buy on that site, including books on how to build a WATER POWERED fuel cell.