Page 1 of 1
Tapered reamer for ball joints/tie rod.
Posted: Sun Jun 09, 2013 5:47 pm
by VooDoo
Looking for one of these. Not keen on paying $100+ to do 2 knuckles and then having one sit in the draw for the next 20yrs. Chasing one to suit GM 1 ton tie rods ( 1 1/2 inch per foot or 7.13 degree's )
http://www.ebay.com.au/itm/Tapered-Ream ... =RTM756594" onclick="window.open(this.href);return false;
Re: Tapered reamer for ball joints/tie rod.
Posted: Sun Jun 09, 2013 7:40 pm
by WICKED
Is it for a street car?
If not just drill the arm out and run a HT bolt with heim joints
Re: Tapered reamer for ball joints/tie rod.
Posted: Sun Jun 09, 2013 9:16 pm
by VooDoo
WICKED wrote:Is it for a street car?
If not just drill the arm out and run a HT bolt with heim joints
Its for a tie rod flip on a CJ7 Jeep (1978)
Re: Tapered reamer for ball joints/tie rod.
Posted: Sun Jun 09, 2013 9:46 pm
by evanstaniland
Low range Offroad sell them
Re: Tapered reamer for ball joints/tie rod.
Posted: Mon Jun 10, 2013 2:57 pm
by nick bj40
i have one i chucked in my low range order for fj80 tierod ends if you are flexable on your tierod choice..