Outer Limits 4x4 Board

hey everyone the speedo on my 91 gq wagon gives a false reading once the car is moving.it either reads a lot less then the speed you are doing or it goes all the way around and sits hard against the pin at the other end of the speedo....any suggestions on fix??? cheers in advance pete

You can try a few things.

Pull it out, pull it apart, clean it and hit every solder joint with an soldering iron to resolder them in case of any dry joints. Some people supposedly have success with this, but I didn't when mine was doing the same.

Another is to replace it with a second hand unit. But from the amount of times I have heard this happening, it could only be a temporary solution.

Most expensive option, costs a few hundred dollars. Take it to an instrument specialist and have them rebuild it. It was the option I chose, so I came away with a brand new calibrated speedo.

thanks rock monkey.do you have to pull the whole dash out to get to it?is there much involved in geting the dash out?..cheers pete

hey rock monkey who did you get to fix ur speedo?

bhundi wrote:hey rock monkey who did you get to fix ur speedo?

A place called NAMIISS in Newcastle

http://www.gauge-shop.com.au/" onclick="window.open(this.href);return false;

I only pulled out my cluster, dropped it into them then picked it up a few days later all fixed up.

I assume you figured out how to get it all out?

yep got it all out.cleaned everything,sprayed with contact cleaner.no change,bugger.still scratching my head on this one...what did they charge you to rebuild youre cluster?

bhundi wrote:yep got it all out.cleaned everything,sprayed with contact cleaner.no change,bugger.still scratching my head on this one...what did they charge you to rebuild youre cluster?

I honestly can't remember, somewhere between $200 and $300 I think. but they essentially just replaced everything. So while it may be a few dollars, how untrustworthy mine was, it was still better then a speeding fine.

cool thanks for the info mate.i sent an email to the that business u recomended.havnt got a reply yet,mite ring them tomorrow.

It could also be the drive gear in the TX case, or the sender in the TX case. The cog on the sender and in the TX case are either a fibre or nylon and if there has been any water in it then it may be damaged.