Page 1 of 1
hilux rhs front tailsharft
Posted: Sat Aug 31, 2013 4:01 pm
by Hiluxpower
Just done. ruf. High steer. And the tailsharft is way to short now it's just a crawler right now so don't on planning going fast with it so what is the best way to make a rhs or pto shaft tailsharft thanks. If any 1 has photos please show
Re: hilux rhs front tailsharft
Posted: Fri Sep 06, 2013 9:18 am
by DUDELUX
As far as I know, 50x50x5, and 40x40x4.
Cut a small groove into 1 of the sides of the 40x40, the seam on the inside of the 50x50 will slide along this groove.
Drill and weld grease nipples as desired, weld double cardan on 1 end, weld uni onto the other.
I havent done this myself, although Ive just done those mods to my junker too, and was considering the rhs shaft, but I picked up a longer driveshaft from a mate instead.