Page 1 of 1
Link material
Posted: Tue Dec 09, 2014 8:32 am
by sht50
Hey guys just wondering what everyone is using for link material? The weld in bungs I have are 1.5"od. I was trying to chase down some 2"x0.25" wall 1020DOM but no one up here even knows what that is even after explaining it. Any other suggestions?
Re: Link material
Posted: Sun Dec 14, 2014 1:35 pm
by uninformed
maybe try getting some "euronorm" or "mecaval" hollow bar
Re: Link material
Posted: Thu Dec 25, 2014 9:24 pm
by evanstaniland
alloy
Re: Link material
Posted: Thu Dec 25, 2014 9:28 pm
by sht50
What type of alloy? And what size is sufficient?
Re: Link material
Posted: Sat Dec 27, 2014 9:45 am
by evanstaniland
7075. Depends on heim size. I run 2" with 1.25" heims and 1.75" with 7/8 heims
Re: Link material
Posted: Sat Dec 27, 2014 10:06 am
by rockcrawler31
evanstaniland wrote:7075. Depends on heim size. I run 2" with 1.25" heims and 1.75" with 7/8 heims
can you say that again please? i didn't hear you the first two times
Re: Link material
Posted: Sat Dec 27, 2014 9:12 pm
by evanstaniland
I didn't double post! Stupid internet
Re: Link material
Posted: Thu Feb 05, 2015 4:03 pm
by sht50
How about erw pipe 60.8 of with 11.07 wall thickness for lowers ( overkill I know but available and 50x50 shs with 6mm wall for uppers.