Outer Limits 4x4 Board

I know the size is printed but what is the actual size difference between this two. I currently have 35in MTR's and am looking at some 36inx12.5x15 Centerpede tyres.

How much bigger are the Pede's to the MTR's. This amount of difference means I may have to sut to fit them.

These will be going onto a SWB MK Patrol at the end of the day.

cheers

James

I don't know about 35" MTRs, but the 285/75-16 MTRs (nominally 33") are narrower across the tread face than 31x10.5-15 Cooper S/Ts - which are close to 265/75-15. If this trend carries to the 35s you may find the 'pedes are wider across the tread face, which could create problems in addition to the nominal diameter increase.

Cheers,

Scott

pic of a 37x12.5MTR and a 35x11.5 ET2 and i belive the 36ET2s are a bit bigger again.

i believe that a 35x11.5x15 centipede is 35.5" and a 36x12.5x15" centipede is 36.2" if that helps, dont know about the exact size of a 35 MTR

jeep97tj wrote:pic of a 37x12.5MTR and a 35x11.5 ET2 and i belive the 36ET2s are a bit bigger again.

in relation to that picture.. wouldnt it look different on a hard ground.. eg theres the MTR on a SOFT ground with a load and comparing with another tyre beside it

TOM

It would make a small dif but i didnt want to take the MTR off cos im lazy

yeah it does make a difference

Simex ET2 - taken from www.simex.com
36x12.5R15 (or R16) = 340mm (13.4") wide and 920mm (36.2") dia

cant help with the MT/R as the goodyear site is crap. Did have a tyre broucher which I think gave the measurements but It floated around the car for so long that it got turfed.


Edit-
Found some info on the MT/R from the US site (it is crap to navigate)
35X12.50R15 = 12.5" (section)width and 34.7" dia ($234US - so $320 aus aint to bad I guess)

40X13.50R17LT = 13.5" width and 39.8"dia $448us