Outer Limits 4x4 Board

Anybody have an mq mk patrol front stub axle around i need the measurment of the axle hole , where the front c/v axle goes thru the bearing's Just the id would be great.
The length of the front and rear axles would be great to from inside edge of the flange to the end of the spline for the rear ,and the full lentgh from end to end for the front. Thanks for any help guys.
Larry. :wink:

Dozoor wrote:Anybody have an mq mk patrol front stub axle around i need the measurment of the axle hole , where the front c/v axle goes thru the bearing's Just the id would be great.
The length of the front and rear axles would be great to from inside edge of the flange to the end of the spline for the rear ,and the full lentgh from end to end for the front. Thanks for any help guys.
Larry.

anyone?

The ID of the stub axle pictured below is 32.5mm. This pic shows the GU locknut in place of the standard 52mm nuts (one also shown) and tab washer.



Cheers