Outer Limits 4x4 Board

Hi I need some more ideas on which tie rod ends to use on my setup.

As it is I am using a hilux diff and intend on using the chaos crossover steer arm.
I think for the tie rod I'll just use standard hilux, but for the drag link I'm not sure as I want to use the standard Isuzu box and maybe re-taper the pitman arm to suit a tie rod end of some sort ie hilux, crusier.

So does anyone know what might be a good fit? as you can see from the pic I can put the arm to the top side of the pitman arm....

thanks in advance for any help

Ok then does anyone know the thread size and taper on an 80 series tie rod end and would this be better than using a hilux one?

Yarno wrote:Ok then does anyone know the thread size and taper on an 80 series tie rod end and would this be better than using a hilux one?

80s is M23x1.5 and have the same tapper as hilux
80s will be better

And does anyone no the deg of the tapper

4sum4 wrote:

Yarno wrote:Ok then does anyone know the thread size and taper on an 80 series tie rod end and would this be better than using a hilux one?

80s is M23x1.5 and have the same tapper as hilux
80s will be better

And does anyone no the deg of the tapper

I am sure you would find this on Pirate, but dunno if the search function is back up over there.

Snakeracing could prolly tell ya.