Page 1 of 1
35 inch tye, rubbing on bundera.........door
Posted: Mon Feb 24, 2003 10:48 pm
by napsta
i just fitted 35's to my bundy, no probs,
EXCEPT
i cannot keep my spare on the rear door anymore, as the smaller barn door will not fit past the tyre to close....
any suggestions?
anyone got a swingaway carrier they want to sell me?
Ben
(another bundy!)
Posted: Tue Feb 25, 2003 7:13 am
by Wendle
Buy a cheap compressor & just carry the spare dead flat so you can squeeze it out of the way to to open the door.
Or redrill the carrier or cut & move it across a bit if you have space on the hinge side for the tyre.
Posted: Tue Feb 25, 2003 4:17 pm
by Aza
got any pics of the bundy with em on??
Posted: Tue Feb 25, 2003 7:56 pm
by Bundytime
space the wheel out about an inch and should b able to close the door then.
Posted: Sun May 04, 2003 7:49 pm
by droopypete
I realise the delay in my response but I have 35s on my Bundy and the spare will fit with a small mod, the pressed metal bracket on the door has another plate inside, through which go the 3 wheel studs, from memory it is located by a few spot welds, drill them off and reposision the stud plate further over to the right of the pressed metal bracket in a posision that lets the left hand door clear the tyre.
Don't move it any more than you need as you will obscure your right hand tail light.
Ihope this helps.
Peter.
Posted: Sun May 04, 2003 8:22 pm
by POS
I have two sugestions!
1. Mark the tyre where the door is hiiting and grind 1/2 an inch of the tread!
2. Mark the door where the tyre is hitting and grind a radius that clears the tyre out of the door!
You can thank me latter for these great sugestions! :wink:
Posted: Sun May 04, 2003 9:31 pm
by hypo
LOL @ POS
Posted: Mon May 05, 2003 9:35 pm
by greylux
Just don't open the door. Simple.
