Outer Limits 4x4 Board

I've just finished reading another topic, [rear wheel bearing on GQ], & was suprised to read how difficult rear replacement is.
Well I was about to attempt the front bearings on my 2000 GU & was planning on just feeling my way through it.
I cut my teeth on full time 4WD rovers & they're dead easy to do [ front & rear bearings are same].
Can someone outline the job for me or should I just take it to a 4WD workshop?

The topic has been covered before. Do a search. If you've done a Rover before, you will find the Nissan very similar except that grease used in the CV's instead of Oil. Bearing pre-load is set with a plate with screws rather than the large nut as in a Rover.

Nick