Outer Limits 4x4 Board

I recently purchased a bullbar for my lux.
It was just over a $1000
That hurt my student wallet so bad it's not funny.
I went to TJM, ARB and various other companies around where I live.
TJM sold me the bar but flat out refused to fit it.
ARB agreed to fit a bar to a 3" body lift but not for anything short of half the price of the bar.

I tried a few smaller shops around the place and couldn't get any that knew what they where doing.

Is there anyone in Perth with the know how that can help me out?

Backyard, Mechanic Shop or even some instructions about how to fabricate plates or modify it to fit.

I'll pay with beer! or money. (just not $500)

t15 bar is it???
pre 97 u should just need to add onto the mounting unit
lift it up a bit
im sure there someone your way that could do it
as im all the way over the ditch

good luck

try a local welding shop.

I went to 'trickyweld' @ the gold coast adn they did me a very good price on lifing my front bar and rear bar. .. thou i chose to do it myself with a mate and his mig.

auto fabrication shops can do it for you as well..

TOM

It's a T13 going onto a 93.
Thanks for the input so far.

i will be lifting a t15 in the next few weeks
from memory thay have the same mount system as the t13

will take some photos of when i do it


only a 2in lift but just add another inch for yours,,,,,