Page 1 of 1
rear axel seal. new question
Posted: Thu Aug 26, 2004 4:47 pm
by muppet_man67
does anybody know if the seals are different on a coilly then a normal widetrack the seals manual that repco has only specifies sj413. Im assuming that means that they never changed however I want to be sure rather then buying the wrong seal. thanks
Sam
Posted: Thu Aug 26, 2004 4:59 pm
by -Mick-
Pretty sure they're the same for all rear wt's.
Posted: Thu Aug 26, 2004 6:49 pm
by 85zook
fuk repco go see suzuki their $7 apiece
Posted: Thu Aug 26, 2004 6:59 pm
by RB zook
my rear diff is leakin from 2 places the the seal is fawked and
the pamhard mount has torn leaving a slight hole
Posted: Fri Aug 27, 2004 10:45 am
by camskizook
85zook wrote:fuk repco go see suzuki their $7 apiece
I agree! When i went to repco they wanted $33 for one
Posted: Fri Aug 27, 2004 2:27 pm
by mud4b
they are the same on the rear...
rear axel oil seal. New question
Posted: Sat Aug 28, 2004 1:47 pm
by muppet_man67
I cant get the old seal out. It doesnt want to budge. any technique or tips from peope?
p.s you were right about repco being a rip off. its $22 or 8 dollars from suzuk. I told the guy that and he said he wouldnt be paying that money either.
Posted: Sat Aug 28, 2004 2:04 pm
by 85zook
To get the seals out i used a large allen key to prise them out but anything 'L' shaped should do the job. To drive the seals in I used , get this, a bed leg. Yes a bed leg!! It was the only thing i could find anywhere that was the right size for the job (my socket set doesnt go up to 60mm).
Take care not to damage the seal seat when removing the old seals as it wont seal properly if they are gouged. Also make sure they are perfectly square before tapping them in (might take a while its a prick).