Outer Limits 4x4 Board

i've got the inner race of the rear output shaft bearing still stuck on my output shaft... anyone found a good way to get this off? transfer case is a landcruiser 4 speed

also hate to ask this, but how do you pull the rear axle shafts in a Full Floating rear axle on a 40 series

try a bit of heat mate... warm up the cage, not the shaft.. should come off with a few degrees diff in temp.

or try a puller.. repco have a selection..

last resort... weld a bar/rod/hunk of steel to the thing and give it a smack...