Spring Over
Posted: Mon Sep 06, 2004 11:02 pm
How hard is it to do a spring over on a SWB MQ?
Page 1 of 1
Posted: Tue Sep 07, 2004 7:32 am
read the bible, heaps of info on it. I'll be starting mine next week!!! hell yer
Posted: Tue Sep 07, 2004 7:49 am
Just a basic SOA should take a weekend to do ........
Mind you if you are doing a knuckle twist on the front diff to alter/correct castor angle then add another day !
A good workshop is pretty essential, Mig & arc welder, oxy, 9" + 4 " grinders, tressels, large floor jack, car stands, all help. A lathe will be handy for driveshaft lengthening but this is better done at a specialists shop.
As above, the bible has plenty of good reading, but dont forget to ask the questions you need before ya start.
Once done you wont go back
Kingy
Praise the lifted
Mind you if you are doing a knuckle twist on the front diff to alter/correct castor angle then add another day !
A good workshop is pretty essential, Mig & arc welder, oxy, 9" + 4 " grinders, tressels, large floor jack, car stands, all help. A lathe will be handy for driveshaft lengthening but this is better done at a specialists shop.
As above, the bible has plenty of good reading, but dont forget to ask the questions you need before ya start.
Once done you wont go back
Kingy
Praise the lifted