Page 1 of 1
buick/holden v6
Posted: Mon Mar 03, 2003 7:41 pm
by zerosin
heres a question....i want to keep a carby engine, have a buick v6 for the toy with one but does anyone know if the manifolds will fit on the holden block?? as the later vp(?) v6 is a better balanced motor and has a better crank (better response/rev range)
Posted: Mon Mar 03, 2003 8:37 pm
by NICK
only the early ones are interchangeable. I believe you'll need a vn v6 bottom end.
NICK
Posted: Mon Mar 03, 2003 11:48 pm
by RUFF
As far as i am aware the Carbed Buicks are totaly different in the port designs to the EFI buicks so i dont think any of them are interchangable.
Also the commodore block has no distributor hole in it at the back of the block under the manifold as far as i can remember.