Page 1 of 1
GQ dash (centre bit) removal???
Posted: Sun Sep 19, 2004 9:46 am
by Boopa
Hey guys,
Trying to work out how the top of the centre dash section is secured so I can remove and install my UHF. I've found the obvious two screws either side at the bottom, and one screw behind the ashtray....but how is the top secured?
buggered if I can work it out
cheers
Re: GQ dash (centre bit) removal???
Posted: Sun Sep 19, 2004 9:51 am
by MKPatrolGuy
Boopa wrote:Hey guys,
Trying to work out how the top of the centre dash section is secured so I can remove and install my UHF. I've found the obvious two screws either side at the bottom, and one screw behind the ashtray....but how is the top secured?
buggered if I can work it out
cheers
There are 2 at the top of each centre air vent.
Posted: Sun Sep 19, 2004 9:51 am
by Daisy
4 screws inside above the air vents
2 screws in ashtray
2 screws on outer low part on left and right side.
Posted: Sun Sep 19, 2004 9:59 am
by MKPatrolGuy
forgot about the ashtray ones
Posted: Sun Sep 19, 2004 10:17 am
by Boopa
Thanks guys.....bit dark in there....should've got off my arse and found a torch to start with.
cheers
Posted: Sun Sep 19, 2004 10:19 am
by Daisy
lol..
when i went to collect my gearbox rubber boot from the wreckers...
they needed to remove the centre dash console,,, took out the 2 screws in ash tray and on the side,,and got a pry bar to rip it out without takin the remaining 4 screws....
until i mentioned it to him (was watchin him while he took everything off)
Posted: Sun Sep 19, 2004 10:35 am
by Boopa
GQ wrote:lol..
when i went to collect my gearbox rubber boot from the wreckers...
they needed to remove the centre dash console,,, took out the 2 screws in ash tray and on the side,,and got a pry bar to rip it out without takin the remaining 4 screws....
until i mentioned it to him (was watchin him while he took everything off)