Page 1 of 1
12.50 tyres
Posted: Fri Mar 07, 2003 3:13 am
by dinos4x4
hello frank you run 12.50 tyres with no rubbing even when you rear axel is at full articulation ?
do the tyres stick out at all legally
because when i get my next set of tyres i might get some 33 x 12.50s
i will have to get some 15x8" steel rims.
Posted: Fri Mar 07, 2003 11:26 am
by DougH
Frank and I have the same setup basically... although I dont know about his wheel offset.
I have 33x12.50's on 15x8.... with a nuetral offset (I asked for this but dont know what I go for sure).
They stick out a good inch or two outside of the fenders.... but they dont rub... even with stock setup. I did have to remove the front mudflaps though.
Posted: Fri Mar 07, 2003 1:46 pm
by dinos4x4
you said the tyres stick out a bit, has your monty got the factory flares
Posted: Fri Mar 07, 2003 4:21 pm
by Bitsamissin
Hey Deano, yes I have 33x12.5x15" BFG muddies (the old style) on 15x8" steel rims.
I don't have any rubbing at the back or the front (unless I fall into a hole too hard and the front wheels rub on the guard).
I have the 15x8" Steelie brand of wheels the ROH Trac 2 will make the tyres stick out about an inch from the factory flared guards.
The Steelie ones are dead lineball with the factory flares.
Go for it dude.......................
Frank.
Posted: Mon Mar 10, 2003 3:02 pm
by Beaast_paj
What model are you people talking about???????
I run 32 by 14 inch dick cepeks on my 85 paj and they dont rub!!!! Don't even have a body lift. The tyres actually stand 33inches high or slightly more because they are on 15 by 7 rims.