Page 1 of 1
H233 5.57:1 differential
Posted: Wed Sep 22, 2004 10:41 am
by bogged
Nissan / Datsun E20 Urvan H233 5.57:1 differential
the one on ebay, wondering if they would fit GQ's? Now that would open up a whole new world!
E20 has 4.6's too...
Posted: Wed Sep 22, 2004 11:04 am
by XterraGuy
Dunno, but if you could find another set and fit 'em, you'd be cooking with gas...
The E20 ones are 10mm bolts crown wheel bolts, that's one thing you'd have to overcome. Pinion likely differs somehow too, could be nothing more than needing to be turned down to accept a smaller ID bearing.
5.875s to be had too...
Brent
Posted: Wed Sep 22, 2004 12:27 pm
by bogged
XterraGuy wrote:Dunno, but if you could find another set and fit 'em, you'd be cooking with gas...
The E20 ones are 10mm bolts crown wheel bolts, that's one thing you'd have to overcome. Pinion likely differs somehow too, could be nothing more than needing to be turned down to accept a smaller ID bearing.
5.875s to be had too...
Brent
complete diff centers maybe?
not for myself, 5.9s would be 10KPH@4k!
Posted: Wed Sep 22, 2004 1:27 pm
by Wendle
you won't be able to find a matching front gearset this side of the x-files though.
Posted: Wed Sep 22, 2004 3:29 pm
by getdirty
Why not run rears in the front...... could work...... maybe
Posted: Wed Sep 22, 2004 3:59 pm
by Wendle
getdirty wrote:Why not run rears in the front...... could work...... maybe
if you used a rear (low pinion) carrier with a front (31 spline) centre, and MQ knuckles to get the tie-rod out of the way it'd work. just not quite as strong.