Page 1 of 1
GU drive shaft prob
Posted: Fri Oct 22, 2004 8:57 pm
by china
front & rear shafts are rubbing on cross members!
front on the t/case, rear on chasy.
is it ok just to cut offending bits out?
it has a 4inch lift is this common? cheers
Posted: Fri Oct 22, 2004 11:31 pm
by ozy1
ok, rear drive shaft, normally from the factory, the rear drive shaft will have the fatter section of th shaft at the top, take it out, and rotate it so the thinner section is at the top (transfercase end)
the front, you will need to notch your cross member,
gu
Posted: Sat Oct 23, 2004 5:49 am
by china
ah yes so simple
cheers
Posted: Tue Oct 26, 2004 11:40 am
by jp
i cut a bit out of my crossmember and welded a bit of tube cut in half where i first cut the bit out if that makes sense? but my gu coil cab has 7"lift and only rubbed on extreme droop...
cheers jp
gu
Posted: Tue Oct 26, 2004 4:08 pm
by china
yep thats what i had in mind. thanx 4 reply
want ave time 2 do it till late nov'