EOI - MK Patrol with Engineered and REg'd 350 - **SOLD**
Posted: Mon Oct 25, 2004 8:51 am
Peoples,
I am afraid the time may have come but it seems I am due to sell my 350 Chev patrol....
List of details below:
9 Months NSW Rego
Engineered 350 Chev with 40,000kms Weiand Manifold and minor work - 20 thou over bore, new pistons bearings etc etc
Gear drive (very quiet though)
Extractors and exhaust
Dual batteries
Electronic Dizzy
Twin VT COmmodore Thermo fans on re-cored radiator
NO RUST!!!! All cut out and replaced properly.
115 Litre LPG set up - runs pure gas not dual fuel.
Good interior - can supply and fit chequer plate interior panels etc etc
Perfect canopy
Kaymar Rear wheel carrier with reverse light
Hella Spot lights x 4
88 x 15 Bathurst Globe rims (5) with AT rubber - excellent condition
ARB Bull bar
Custom Rear bar (9mm steel plate)
side Steps
Roll bar
I have a number of bits I am willing to give away with it - 3 or 4 inch body lift, 3 inch spring lift with Pro Comp Shocks and what ever parts you may desire - I got heaps...
What would you guys pay for a beast like this..... it screams people...
I am a tad over playing with cars these days and I am probably just going ot but a normal car or a beater L28 stocker and just hack it up and stuff so I don't care if I break her too bad... plus I can use it for shootin again....
I am afraid the time may have come but it seems I am due to sell my 350 Chev patrol....
List of details below:
9 Months NSW Rego
Engineered 350 Chev with 40,000kms Weiand Manifold and minor work - 20 thou over bore, new pistons bearings etc etc
Gear drive (very quiet though)
Extractors and exhaust
Dual batteries
Electronic Dizzy
Twin VT COmmodore Thermo fans on re-cored radiator
NO RUST!!!! All cut out and replaced properly.
115 Litre LPG set up - runs pure gas not dual fuel.
Good interior - can supply and fit chequer plate interior panels etc etc
Perfect canopy
Kaymar Rear wheel carrier with reverse light
Hella Spot lights x 4
88 x 15 Bathurst Globe rims (5) with AT rubber - excellent condition
ARB Bull bar
Custom Rear bar (9mm steel plate)
side Steps
Roll bar
I have a number of bits I am willing to give away with it - 3 or 4 inch body lift, 3 inch spring lift with Pro Comp Shocks and what ever parts you may desire - I got heaps...
What would you guys pay for a beast like this..... it screams people...
I am a tad over playing with cars these days and I am probably just going ot but a normal car or a beater L28 stocker and just hack it up and stuff so I don't care if I break her too bad... plus I can use it for shootin again....
