Outer Limits 4x4 Board

so, how do you do it? the bigger pins hold the spider gears, and then there are the little pins that hold the big pins in place.

i've taken the little pins out, so how do you get the bigger pins out? someone mentioned that on the sierra carrier, the pins only come out one way, is this the same? i think on the sierra carrier, the ring gear holds the pins in place.

this is so frustrating. can any one help?

thanks
steve

Call Sam @ Overkill

he has the axle from the X90 he's SASing for sale at the moment

(CV's have already been sold)

Mine slid out easy after the smaller pins had been removed, they aren't bent at all are they???

i just cant take the one of the half pins and the long one out. they don't look bent, and there is about 5mm of play. the pins won't slide through the spider gears, or the spider gears wont allow the pins to slide through.

i noticed that there is a machined section/flat spot on the pins, what is this for? the spiders seem to be held in place by this or something.