Page 1 of 1
tail shaft
Posted: Wed Nov 03, 2004 7:22 pm
by HUNTERLUX
i need some names & contact details 4 any1 around sydney who does costom tail shafts
Posted: Wed Nov 03, 2004 7:46 pm
by 65Mog
J Mac, Diff & Gear at Arndell Park (near Eastern Creek) 9671 5800.
shafts
Posted: Thu Nov 04, 2004 8:40 am
by 82 Lux
Richard Day at Pitt town 45723231
Posted: Thu Nov 04, 2004 8:58 am
by STUMPY
Tailshafts
Posted: Thu Nov 04, 2004 9:40 am
by Frenzal
I'll second that. Offroad did an awesome job on my GQ.
dse
Posted: Fri Nov 05, 2004 7:13 pm
by aloa9061
drive shaft engineering
Re: dse
Posted: Fri Nov 05, 2004 7:31 pm
by spazbot
aloa9061 wrote:drive shaft engineering
heard a few bad stories bout this mob
Posted: Fri Nov 05, 2004 10:28 pm
by Squik
There's a mob in Granville on James Ruse Drive...can't remember their name but they've done quite a few for us.
Driveshafts
Posted: Mon Nov 08, 2004 6:46 am
by Frenzal
Squik wrote:There's a mob in Granville on James Ruse Drive...can't remember their name but they've done quite a few for us.
Universal Driveshafts...I think.....I've tried them a few times but they're very expensive...especially for custom work.
Posted: Tue Dec 14, 2004 4:01 pm
by Slunnie
They are Metropolitan Driveshafts on James Ruse Drie at Granville. 9637 7933. I crawled under the Disco today, DC was shattered, pulled it out took it down to Metro Driveshafts (10mins after close) and they guessed $400 to rebuild the DC and a uni. They will quote by 8.30am tomorrow and have it ready to pick up at 4pm tomorrow.
Now that is service! I went in hoping for it before Xmas.
Posted: Tue Dec 14, 2004 4:25 pm
by Busiboy
ORI did mine too, those guys saved my biscut!!
looked after me really well
DSE
Posted: Wed Dec 15, 2004 7:59 am
by Roctoy
ANYONE BUT DRIVESHAFT ENGINEERING AT KIRRAWEE HEY MACCA!
Posted: Wed Dec 15, 2004 6:46 pm
by professor
Glenn Dobbin does a kick ass tail shaft it has a 10" slip ans runs an 100 series cv instead of a uni
They work well for me and they are made to any lenght
www.dobbinengineering.com/
Posted: Wed Dec 15, 2004 7:53 pm
by HUNTERLUX
thanx fellas but i used hardi spicer at morebank
12" extended spline front
1piece extended rear
$540