Outer Limits 4x4 Board

Just wondering is it possible to fit 31's to a feroza without a spring or body lift, an whether the wheels have to be offset... girlfriends considering buying one an ive gota make it look a little beefy!!!!

No.

You'll need a 2 inch spring and 2 inch body lift to clear them at full lock. You might get away with one or the other if it's not gonna get wheeled hard.

Go for 235x75's, they look good on an offset rim and dont screw the gearing too bad, as Ferozas don't have a great reduction.

Where are you and when are you looking to buy? I might know of one for sale in the next few months...

I'm looking at going 30x9.5.. And putting in a 2" Suspension lift..

Wanted to go 31's for width, but been told it i'll need more lift also.

i used to have 31 on my old feroza and they just rubbed on full lock with full compression and that was with about 2 1/4 lift at the front and about 2 1/2 at the rear. front is easy to lift just remove sway bar and wind up torsion bars. rear has to be reset or replaced. new springs and longer shackles is the best way to go (thats what i rekon others will differ)

I've got 31x 10.5's on my standard Sportrak. They fit fine as long as you take off the mud flaps. Same as 'Built4thrashing' mine rub on full lock and full compresion - nothing to worry about!

They fit easy with a 2 inch body lift.
Here is a pic with my old 31's... i now have a set of simex centerpedes. They rub a bit on full lock if i have a bit of travel on the front wheels

[/img]

Hi, folks.

My 94 Feroza SX is running on 31 x 10.5s with the stock suspention and body. It rarely rubs a bit on the front wheels, but in general they fit allright.

Cheers, Alexandre Coco