Outer Limits 4x4 Board

Guys, what's the WMS width of the Rangie rear diff? Any differences in year models or are they all the same? Are the full floating or semi floating setup?

Thanks

I think the Classic rangies are full floaters and the P38a's are semi floaters. Not sure what the WMS are though.

Classic is full float.

And I thought the P38 was as well.

Michael.

I'm pretty sure the P38a and D2 share the same axles. The D2 is definately a semifloater. Hmmm, conflict - not sure then Michael.

Slunnie wrote:I'm pretty sure the P38a and D2 share the same axles. The D2 is definately a semifloater. Hmmm, conflict - not sure then Michael.

P38's and D2's do not share axles, but they are of similar design - non floaters.

wilsby wrote:

Slunnie wrote:I'm pretty sure the P38a and D2 share the same axles. The D2 is definately a semifloater. Hmmm, conflict - not sure then Michael.

P38's and D2's do not share axles, but they are of similar design - non floaters.

It is such a shame Land Rover made the backward step from full float to semi float - after doing away with it in about 1954!!! Once the defender is replaced it will probably be all downhill unfortunately.

Thanks fellas

The WMS measurement would still be handy if anyone else reads this, off a classic rangie to be precise.

Damo wrote:Thanks fellas

The WMS measurement would still be handy if anyone else reads this, off a classic rangie to be precise.

Just measured rear as close as I could, was 1556mm.

Bush65 wrote:

Damo wrote:Thanks fellas

The WMS measurement would still be handy if anyone else reads this, off a classic rangie to be precise.

Just measured rear as close as I could, was 1556mm.

Thanks John! I'd email u a beer if I could