Page 1 of 1
Valve clearances L28 MQ/mk
Posted: Sun Nov 28, 2004 3:47 am
by jonny
Your help again please ,Iknow the gaps to set these but any advice on how to set correctly would be a great help .....Also what order are the inlet and exhaust valves in ?I do not have a manual to give me the order(is it always the same in a straight six?)Thanks for your help ,Jonny
Posted: Sun Nov 28, 2004 7:03 am
by V8Patrol
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=22197
all the answers are there ...... or below !
Valve Clearance HOT
Intake - 0.25mm
exhaust - 0.30mm
Engine Oil Cap with filter change
-4.4L
Cooling system cap with heater
- 10.8L
Radiator Cap Relief Pressure
-88 KPA
Compression Pressure
standard - 1177 KPA
minimum - 883 KPA
Ignition Timing and idle speed
- 8 degrees at 650 RPM for manual trans
- At Idle Co % 2.0
Point Gap
-0.45 to 0.55mm
Dwell Angle
- 35 degrees to 41 degrees
Spark Plugs STANDARD
-BP6ES
-0.8 to 0.9mm
High Tension cables (leads)
-Resistance less than 30000 ohms
Kingy