Page 1 of 1

31in on a rocky

Posted: Tue Nov 30, 2004 4:53 pm
by rockman
got my self a 1990 2.8 turbo rocky and want to put 31in tyers on it but dont think they will fit i got the springs re set higher but think i need to put a body lift or get some extended shackels. what have you guys done. :P

Posted: Tue Nov 30, 2004 8:34 pm
by inka
2" spring lift, 2" body lift and will still have to cut back rear guard.... :bad-words:

keeping in mind that springs i am running flex a lot so this is why guards rub at full articulation..

also tyres are simex extreme trekkers..

Posted: Wed Dec 01, 2004 5:13 pm
by rockman
has any one got longer shackles. do i have to make them my self or can you buy them off the shelf

Posted: Wed Dec 01, 2004 6:11 pm
by jabboo
give surfection a PM
he's making me up a pair
mines not a rocky but im sure he can still make it

Posted: Thu Dec 02, 2004 7:55 am
by bullwinkle
We have a 2in suspension lift in our rocky and the only problem we have is the front tyres tend to just touch inside the front guard, so we are going to put in some slightly bigger shackle to compensate. We have got 31" maxxis mudders underneath and they are a great tyre for a cheapo - brilliant in the wet.

Posted: Sun Dec 12, 2004 9:17 pm
by Spartacus
i got 31s on my rocky with a spring reset?

only problem i got is them scrubbin the leaves at close to full lock

gettin spacers or deep dish rims for xmas

Posted: Mon Dec 13, 2004 8:35 pm
by lay80n
i had 31's with custom springs (bout 2 inch but mega flexy) and i just modified the inner guards with hammer and grinder. still rubbed both ends but not too bad. With shackles the chassis width of the shackle is different to the spring eye, and at the front they caould still touch not too bad, and at the rear they rubbed in the inner guard slightly. A 2 inch body lift would have been good, but by then the zook was runnin, so i sold the rocky. Also 31's are on the edge of the factory gearing, esp if ya into crawling.
Layto....

Posted: Tue Dec 14, 2004 3:11 pm
by Busiboy
hmm what are the biggest tyres you can fit under a 92 rocky with a 2" body lift and 2" suspension lift?

Any ideas, asking for a mate

Posted: Tue Dec 14, 2004 7:55 pm
by lay80n
Depends on what he wants. Once you go to over 31's, the gearing is very poor (average to start with). Without swapping axles to lux axles or similar axle with wide range of ratios and lockers available. there isnt much you are able to do bout it. Having said that, if you arent into rock crawling or dont need low gearing, 32's would prob fit, depending on rim offset and actual brand of tyre (all brand measure up different, e.g. my MTR's on my zook are slightly smaller than my set of bfg muds even though they are same nominal size.) If ya mate wants bigger tyres, then guard modification might be worth a look too.
Layto....

Posted: Tue Dec 14, 2004 8:04 pm
by Busiboy
Thanks for the reply, so in short over 31's you loose too much gearing and have to bend stuff.

31's sound like the compromise of choice?

EASY DONE

Posted: Thu Dec 16, 2004 7:43 pm
by RockyWeapon
I had 31x10.5's on my 85 rocky, std front springs, raised rear, not a problem at all. i reckon theyd still be fine with std rear!

Posted: Thu Dec 16, 2004 9:36 pm
by BabyGodzillaGTi-R
I'm running 31 inch too.
And yeah the gearing is a total crap on the Rocky.
Anybody out there wanna let go final drives from a F20 Daihatsu Rocky/ Toyota Blizzard/ Scat? Heard they are 4.8.

No problem with the tyres hitting except that i find the front tyres hitting the leaf spring on full lock. Probably need more offset.
Currently running 3-4 inch suspension lift.

I've seen Rocky's running with 32 inch but require abit of front fender trimming when running 3 inch lift.

But the craziest i've seen is 35inch Extreme Trekkers on a Rocky running SPOA. Looks crap going up and down hill but outperforms my rig in deep ruts and muddy conditions .

Posted: Fri Dec 17, 2004 9:24 am
by Area54
BabyGodzillaGTi-R wrote:I'm running 31 inch too.
And yeah the gearing is a total crap on the Rocky.
Anybody out there wanna let go final drives from a F20 Daihatsu Rocky/ Toyota Blizzard/ Scat? Heard they are 4.8.

No problem with the tyres hitting except that i find the front tyres hitting the leaf spring on full lock. Probably need more offset.
Currently running 3-4 inch suspension lift.

I've seen Rocky's running with 32 inch but require abit of front fender trimming when running 3 inch lift.

But the craziest i've seen is 35inch Extreme Trekkers on a Rocky running SPOA. Looks crap going up and down hill but outperforms my rig in deep ruts and muddy conditions .


The earlier F10 had 5.5:1 final drive. :shock: :shock:

Posted: Tue Dec 21, 2004 5:03 pm
by rockman
whats the fuel like on the open road dose it go through more with 31. i throught that the diameter of the wheel is biger so your going ferther so less fuel but apprantly thats wrong? any one know how wide the rims have to be to fit 31 is 7.5in ok?

Posted: Tue Dec 21, 2004 5:52 pm
by inka
fuel not too bad if petrol version :)
basically on highway revs are lower at same speed but using a little more right foot to keep it there if that makes sense ;)
also getting up to speed takes a bit longer

Posted: Tue Dec 21, 2004 7:46 pm
by Spartacus
hey rockman where are u at in oz?

Posted: Wed Dec 22, 2004 4:37 pm
by rockman
im in adelaide not many places close to go 4wd at that i know of. not to keen on 31 if i gota stop at every fuel station when i go away might just get 30in tyers

Posted: Wed Dec 22, 2004 5:52 pm
by inka
the difference isn't that extreme and it depends on what brand 31" your using
simex extreme trekker is what i am running offroad which are sold as 31" but measure closer to 32.5" so bad example of 31" economy ;)