Page 1 of 1
pulley manufacturer
Posted: Mon Dec 13, 2004 8:17 pm
by cplux
Hi there does anyone know of a machine shop capable of machining a 4/5 rib pulley. It is to fit onto the front of my supercharger which is an sc14 toyota jobby off a 1ggze
Posted: Mon Dec 13, 2004 8:38 pm
by benno_from_brizvegas
Sorry I don't know but i'd be interested to find out too.
What is the SC14 going on? Been looking at putting the SC12 on my 2.4 lux.
Benno
Posted: Mon Dec 13, 2004 8:54 pm
by cplux
it is on a 4yc petrol hilux. I'd go the sc14 for a 2.4 diesel and it should be piss easy to setup compared to mine (petrol)
Posted: Mon Dec 13, 2004 9:40 pm
by RV80
You want to find a race engine type shop
some would of had to have weird pulleys
made up for them before.
Posted: Mon Dec 13, 2004 10:19 pm
by ShortyMQ
Any good engineering shop should be able to make 1,probably wont be cheap tho.
Posted: Thu Dec 16, 2004 3:31 pm
by Tiny
what he says........any good hand at a lathe should have no probs
stuff
Posted: Fri Dec 17, 2004 8:19 am
by ratboy
i made them on my lathe any one who has a lathe should be able to do it
very easy no spe tools needed
Posted: Sat Dec 18, 2004 8:40 am
by Paul
I've needed poly-rib pulleys in the past and after talking with a few machine shops, decided that it would be cheaper to find a pulley of the appropriated diameter at a wrecker, cut the centre out of it and either get an adaptor made (bolted on to my harmonic balancer in this case) or in the case of my AC compressor, cut the centre from my stock AC pulley, the outer portion of a Rodeo PS pump pulley and had the two welded together.
Paul.
Posted: Sun Dec 19, 2004 12:10 pm
by 4sum4
can do it at my work not sure about time though pretty busy