Page 1 of 1
Bobbing the back of a GQ
Posted: Sun Dec 19, 2004 6:37 pm
by Beastmavster
After a couple of bits of damage to the rear of the GQ (yeah EVERY time I go out) im thinking of bobbing the back and getting a tube bar.
How have most people done it - cut well below the crease line and bashed it up into a _| shape with a rubber mallet and then tack welded?
Posted: Sun Dec 19, 2004 7:15 pm
by AndrewPatrol
Have a look in the GQ bible at the top of nissan page
You'll find this :
http://www.outerlimits4x4.com/PHP_Modul ... php?t=7164
and this:
http://www.outerlimits4x4.com/PHP_Modul ... php?t=9175
lots of other stuff too
Andrew
Posted: Sun Dec 19, 2004 7:24 pm
by Beastmavster
ahhh... rear 1/4 cuts.... not bobbing no wonder I couldnt find it
Posted: Mon Dec 20, 2004 5:30 pm
by bigsteve
Beastmavster wrote:ahhh... rear 1/4 cuts.... not bobbing no wonder I couldnt find it
Aus4wd has blanks that fill the holes, perhaps a call to them could see you shipped with a set.
Posted: Mon Dec 20, 2004 6:32 pm
by L-Stefan
Posted: Mon Dec 20, 2004 6:54 pm
by Daisy
www.cheezyracing.com.au check out his pictures section of 'rear bar'
They look nice i gotta admit.
Im just waitin for him to get approval for the integrated towbar attachments (takin forever from standards australia
)