Outer Limits 4x4 Board

can anyone tell me if it woudl be ok to use a 2.4td fuel pump on a 2.4?
is it possible to turn the fuel pressure down in them so they pump as much as a normal 2.4 would?
just need to knwo because my seals have gone and i have been offered a 2.4td pump with new seals in it for 150
any help

I can't see any prob with it. They do have adjustment and are prob the same pump. I've had a 2.4 pump on my last 2.8 engine and they simply wound it up for the bigger engine and turbo etc

I can email you the instructions & diagrahms on how to change the fuel volume, i've done this a few times now when I've setup turbos for mine & mates utes!

From memory you need to turn it clock wise until the smoke clears up under load.

You gonna fit this instead of getting seals in your current pump??

I just bought another sr5 2.8 (dual cab), and tonight I noticed the pump is leaking from underneath, looks like I have to pull the pump out this week & reseal, lucky I still have my 92 sr5 (xtra cab) to run around in (My wife won't part with her xr6 falcon)

Russ

yeh i was looking at it as an option cause i realy dont wont to pull the pump apart myself so it is going to cost around the 200 - 300 dollar mark if i just take the pump in. so if this pump has new seals and fits and everythign will work fine then i will do that and save myself some money.
if you coudl send us the diagram on how to do it it owuld be muchly appreciated

I asked the same question at one stage

http://www.outerlimits4x4.com/PHP_Modul ... ector+pump

Hope this is of some use!

thebrunks wrote:I can email you the instructions & diagrahms on how to change the fuel volume, i've done this a few times now when I've setup turbos for mine & mates utes!

From memory you need to turn it clock wise until the smoke clears up under load.

Russ,

I'd be interested in those instructions too. Could you pleaes email to: killasurf@westnet.com.au

Cheers,
Cal