transfer lift
Posted: Fri Apr 04, 2003 4:47 pm
i am making a low profile crossmember for my hilux and just wanted to know how far the transfer/gearbox can be lifted without raising the engine mounts.
cheers
cheers
Page 1 of 1
Posted: Fri Apr 04, 2003 5:03 pm
yeah i wanna know this also
Posted: Fri Apr 04, 2003 6:55 pm
I have lifted mine 5 inches and havent touched the engine mounts 
Posted: Fri Apr 04, 2003 6:56 pm
But i think my floor is going to have issues with it
Posted: Fri Apr 04, 2003 8:31 pm
RUFF wrote:But i think my floor is going to have issues with it
but i think my nuts might.
i have lifted mine mmmm dunno how far, but it is 40mm below the chassis. I didnt lift my engine but i did fit the mounts upside down and this lifted the engine an inch.
NICK
Posted: Sat Apr 05, 2003 3:34 pm
NICK wrote:RUFF wrote:But i think my floor is going to have issues with it
but i think my nuts might.
i have lifted mine mmmm dunno how far, but it is 40mm below the chassis. I didnt lift my engine but i did fit the mounts upside down and this lifted the engine an inch.
NICK
is it possible 2 install the mounts upside down on a 2.8 diesel ?? and can u get a closup pic nick ??
Posted: Sat Apr 05, 2003 3:56 pm
not sure, have a look at the mount and if it looks the same upside down, bar the fact that the bolts are upside down then yes it will work.
NICK
NICK
Posted: Sat Apr 05, 2003 4:17 pm
yeah ok cool will look into it more