Outer Limits 4x4 Board

Thinking about getting rid of 90% of the front 1/4 panel

The red lines would be tube, running from the tube bar attaching to the firewall (is that possible???)

All the blue bits would be gone

Would this work ok?

Can anyone dig up actual pics (yes i searched, all the ones i could find they replaced the whole fron end - like what Overkill did)

Hmm a toob front clip on a vit.

Twistedmetal on pirate sort of did this but he ran 2 toobs which effectively re-created the front guard (moving the wheel arch forward.

Change your link to show the blue scribble totally blacked out, that should make things easier to visualise.

done

back to pirate to search then

I actually think it would look really good done properly

I have a few pics of it at home, can link them later if you haven't found it.

It was a gold/orange colour with an axle swap, hydro & sx swampers (from memory)

would that be legal on road?

I think that looks a bit Grimace, and i wanted to keep the panel work between the wheel and the engine

I was trying to find the pic of Sams serria that won the best hardcore in 4wd monthly 2002, anyone got it?

SiKiD_01 wrote:would that be legal on road?

I dont see why not, as long as things like flairs and sharp edges were taken care of

Like when Sams was like this












Shonky photos i know

are you going to keep some of the quarter or just go tube under the bonnet like those pics

keep the bit above the red line

Gonzo wrote:keep the bit above the red line

Just checking go with that

How about this one. Just the front bit.



heheh

nicbeer wrote:How about this one. Just the front bit.



heheh

I've always loved that thing