Outer Limits 4x4 Board

Hey Guys,

has anyone got any suggestions on putting carpet in a 40. I want to put some heavy duty marine carpet in. I aslo want to keep the joins to a minimum. Any suggestions would be greatly appreciated.

Thanks

Easiest way if you wanted the least joins possible would be to take all the seats etc out... get a length of carpet which is long enough for entire car.... as a broardloom meter will cover the whole width... and then just cut it in as you need it to be shaped... then put your seats back in... best to glue it down unless you will want to take it out every now and then.

that will give you no joins and a nice peice of carpet heh.

andrew.

mate mine came with marine carpet in the front but only between the seats and fuel tank.
old matey just used really thin aluminium sheet and made up like a cover and marine carpeted it in black. the rear has a thick rubber mat.

There are places which sell them, retail is around $160

try Protectormat or dept of the interior.

mine is stuck onto the guards in the rear and then one square on the floor in the rear, held on by body deadener

front is a rubber toyota job, hose out etc is good, pressure washed the rear carpet, it is a poly type carpet with no hessian crap and works well