Page 1 of 1
cruiser rear axle stud upgrade.
Posted: Tue Jan 25, 2005 3:18 pm
by bazooked
any 1 got the link for the 8 to 10 mm upgrade i cant find it..............
Posted: Tue Jan 25, 2005 3:54 pm
by MQ080
PM dumbdunce
Posted: Tue Jan 25, 2005 4:11 pm
by bazooked
found it......
just wasnt sure about the tapperd cones as there is not much meat in the 75 series axles.
Posted: Tue Jan 25, 2005 4:21 pm
by RV80
Just replace the original ones. If you renew them every
2 years you shouldn't have a problem and you'll always
have spares. That's what i did.
Posted: Tue Jan 25, 2005 4:39 pm
by HEY CHARGER
this might help a little bit,
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=11856
also in jan 4wd monthly theres a bit of a spread.. page 197
Posted: Tue Jan 25, 2005 5:29 pm
by rock hopper
I do a mod to the hub - axel
there is not enough meat for strength using a 10mm stud .
i do a mod to axel and hub $60-00 a side (using your hub + axel)
i use std 8mm studs - std dowls.
i have all the jigs to do this mod .
i can supply new hubs and new axel .