Outer Limits 4x4 Board

Hi all,
I'm having a few problems with my 60 after fitting a 2 inch body lift. As expected the transfer case lever was fouling the floor so I have cut an inch or so out with the angle grinder to compensate. I took it for a test run this morning and even though I am getting low range gearing, there is still no drive to the front wheels??? Yes, hubs are locked... There was a bit of a grinding noise when I first put it into low range (before I chopped the floor) so I am a bit worried that I have damaged something. Any info would be great, should I keep chopping for more clearance or should I take a different route and bend the lever instead?
Thanks.

I like bending stuff

maybe the vacuum hose has come off the transfer case..

i spent 12 months in 4high cause the auto lecky told me the
solenoid was bung... i finally looked at xmas to find the hose
unattached

i had no probs lifting my rocky...strange...

Thanks, I'll check it out.

Don't know what your problem is without seeing the car. I extended both levers by 50mm when I did my lift so it feels normal while driving.
Good luck, hope you find the problem.