Outer Limits 4x4 Board

Where do you get steel tube 90 degree bends?

Am going to use these to make a replica ARB roof rack. I don't have access to a pipe bender so I figure this would be the next best step.

I need maybe 1 inch diameter pipe

In Brisbane are preferably.

Cheers

steel supplies... short radius or long available...

wherever you can source pipe, should get bends to suit..

would recommend black steel, galvanise later or powder coat..

Spock

That's be the go.

The round tube roof racks look better than the square ones I think.

Might try Gateway steel supplies.

Cheers

their correct name is butt weld bends any steel suppies or irrigation joint.

porters engineering on the sunny coast has them. about $5 each for cast
short radius 1xdiameter long radius 2x diameter also have 3xdiameter bent pipe ($18 odd each)