Page 1 of 1
where to buy bodylift block material (sydney west)
Posted: Wed Feb 09, 2005 8:43 am
by James_Murray
I am looking for body lift blocks - 30mm. I am fine to cut and drill them if I can get the rod. I am looking for the white plastic stuff, think it is called UPHW?
If I buy them from a 4wd shop, I have been quoted $30ea - not a chance and I need 13 of them.
Thanks, James.
Posted: Wed Feb 09, 2005 8:55 am
by De-lux
i got polyethalene from a plastics joint here in brisbane for $40 for a metre
Posted: Wed Feb 09, 2005 9:20 am
by James_Murray
De-lux wrote:i got polyethalene from a plastics joint here in brisbane for $40 for a metre
Thanks, for the reply. Found the stuff now, just around the corner
Posted: Wed Feb 09, 2005 9:48 am
by Busiboy
Ages ago I got alloy ones made up at an engineerng mob for $40, alloy dowel all cut to 50mm 6 of!
Posted: Wed Feb 09, 2005 9:54 am
by Roctoy
EPLAS at Blacktown to good prices on Acetal rod.
Posted: Wed Feb 09, 2005 9:54 am
by James_Murray
Right, so I have decided to go for the plastic ones - mainly to minimise any squeeks.
They tel me the pick is the black material, I am happy with that for the simple reason in will look more factory, but they say it is tougher stuff compared to the white - is this going to cause a problem?
Thanks, James.
Posted: Wed Feb 09, 2005 10:16 am
by Area54
no probelm with the tougher material, you need it rigid so you can torque down the bolts correctly. 13 for your rocsta
thats a lot. Can't criticise the koreans logic though.