Outer Limits 4x4 Board

I am looking at getting front and rear lock-right lokkas for my 96 Solid Axle 2.8D Hilux. I visited http://www.rocky-road.com/lockright.html and am unsure of which ones i need, anyone able to clear this up for me?

Also heard that you can't put a lokka in a LSD ? is this the case?

Also am looking at moving my front axle forward an inch or so so I can fit on bigger rubber. Any instructions, hints on what is required would be appreciated..

There is a table on the site that will advise of which one.

As far as not being able to put a locker in an LSD - that is not true.

However, with many diffs you are essentially replacing the LSD with the locker. I am unsure baout the LOKKA brand itself - but I know a guy or two with a LOKKA locker and they definately had LSD before hand.

Hmm..

I re-visited the site and cant seem the table anywhere - all I can find is the shapes of diff difs but Toyotas aren't mentioned on this page either..

If you can find it reply with the url please..

Sorry - my bad. I was looking at the ARB air lockers.

I checked 4wd systems (an aus supplier), and they didn't say either. Try emailing the company.

hey If you are looking at the lunchbox lokkers as the say in the US they go into your original diff carrier eg replace spider gears etc so i think that it would not work with a lsd maybe wrong tho.
If its the full lokka eg detroit nospin or ARB types they replace the whole carrier and the ring gear bolts to it the lokker itself so doesnt matter if a lsd or not kus you wont be using the carrier
Hope this helps

Clown Boy wrote:Sorry - my bad. I was looking at the ARB air lockers.

I checked 4wd systems (an aus supplier), and they didn't say either. Try emailing the company.

You won't get a response Call them or nothing I'm afraid

0011 1 435-654-1149

the no. from aus. I got my locker for under $300 to my door in a couple of weeks no hassles

you can get a lokka for the lsd..its slightly different than for the front and uses some of the lsd parts... put one in mine..best thing i eva done...least till i get the detroit

Grr..

I rang them and they were unable to find out which ones I needed so I rang powertrax and after being on hold for 10 minutes i hung up.

anyone got an idea on whcih ones I need for the LN106 or know where I can find out?

I cant tell you about which lokka you need, but on the rocky road site it gives you a table to choose from depending on spider gears etc. If you look at your plate that tells you model number frame numder you will see that there is a bit that says "trans/axle" and then has 2 codes stamped in. the second code is about your axles. In you truck it probably says "g282". "g" means 8 inch diff. "28" is your ratio (in this case 4.3). and the last number is about your spiders etc. "2" means 2 spider gears, open. "3" means 2 spider gears, lsd. "4" means 4 spider gears, open. And "5" means 4 spider gears, locker. Does that help?
Hope so.
Cheers.
Arron.

Thanks.. i'll check it out this arvo when I leave work.

chace it on e bay and look for your model then go to the distributer i think its rods diff services

I suspect that some time in the last 6 years Whiteknight has sorted it out.

yeah all sorted an have had 3 different vehicles since then too

hey mate

if this is any help im dismantling my hilux ln106 have 2 lokkas im selling the rear one is basically brand new put it in about 1000km ago then my engine went, the front is bit older but they are unbreakable mate. ill sell them both too ya if you want. pm me and let me know if i can help you out?