Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

chassis

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 3739
Joined: Sat Dec 11, 2004 10:10 pm

chassis

Post by mickyd555 »

so what would you do if your chassis rail had a big crack in it cause its rusting from the inside out.................... :roll:
Top
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Contact:
Contact Nev62

Re: chassis

Post by Nev62 »

mickyd555 wrote:so what would you do if your chassis rail had a big crack in it cause its rusting from the inside out.................... :roll:


Ditch the chassis :!:
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Top
Posts: 3739
Joined: Sat Dec 11, 2004 10:10 pm

Post by mickyd555 »

really, is it that bad............

what about 200 rolls of stickytape?


ok, i thought it might come down to that. it seems that the chassis is only rusted really badly at the lowest point, its a ute, so i was thinkin maybe i could cut out the part that is badly affected and make it a mid wheel base, i think someone on this board has doen that, but i cant remember who? what are your thoughts?
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests