Outer Limits 4x4 Board

Standard rears for SWB....

Is there anyway trick way to undo the dam nuts and get the bolts out????

I cant even make the nuts budge at all on the back...........

i need to change a bent one....

May have to pull the oxy out, just curious if anyone has any tricks?

screwy

I use a 3/4 breaker bar, about 450 long. They go "Crack" then act as normal.
Try a bit of tube over your large double ended ring spanner that you should be using

Bazzle

use the same trick as i did on the body mounts...............................................

yeh tried above and it dont wanna move......
just rounds the socket off the top of the nut....

Ill just use abit of heat

Screwy_ScrewBall wrote:yeh tried above and it dont wanna move......
just rounds the socket off the top of the nut....

Ill just use abit of heat

single hex sockets are your friend in this case.