Plastic togle switch dash board blanks
Posted: Fri Mar 11, 2005 2:50 pm
I have an 93 Mav. The previus owner had installed driving lights and the switch gear was located below the radio in the dash. There are a number of clip out oblong black plastic press in fittings where you can install switches and alike. One of the fittings has broken a tab which secures it into the opening. I want to replace it and all I would have to do is drill a hole in the fitting , mount the switch install the plastic fitting.
Are these a special Nissan fitting or industry standard. Can you get repo's or should a wrecking yard be the go. I pulled out the coin??? retainer thingy located in the bottom right hand corner of the dash and there are about 3 openings behind that where I could add further switches.
Are these a special Nissan fitting or industry standard. Can you get repo's or should a wrecking yard be the go. I pulled out the coin??? retainer thingy located in the bottom right hand corner of the dash and there are about 3 openings behind that where I could add further switches.
