Page 1 of 1
Extractors - Where to buy? Recommedations!!!
Posted: Tue Mar 22, 2005 9:34 pm
by mvanbasten9
I wanted to replace my factory cracked extractors and was wondering what anyone else replaced them with. Where? How Much? And How Good?
Thanks all........
Posted: Wed Mar 23, 2005 12:00 pm
by Timmy
where are you?
Posted: Wed Mar 23, 2005 12:01 pm
by Timmy
where are you?
Posted: Wed Mar 23, 2005 12:05 pm
by Timmy
where are you?
Posted: Wed Mar 23, 2005 3:37 pm
by Wooders
Common problem.
If you go after market get the Banks IMHO.....
Posted: Fri Mar 25, 2005 11:04 am
by mvanbasten9
In melbourne!!!
And what are they worth roughly???
Posted: Sat Mar 26, 2005 10:36 pm
by millhouse
most places charge about $600 for aussie brands fitted
I run the banks brand cost me about 500 to land from the usa
and about a day to fit them, best mod i've done so far
Posted: Mon Apr 11, 2005 3:38 pm
by `maddog
Some thoughts for you.
- Get stainless steel extractors. They're worth the extra money
- Get them ceramic heat coated
- Make sure whichever brand you do end up getting doesn't route underneath your sump, as it will get crushed the first big rock you go over.
Posted: Mon Apr 11, 2005 6:40 pm
by skippy's GQ
just weld the old one up, it takes about 2 hours in total and only cost $30 for a new manifold gasket. I repair them all the time at work
Posted: Fri Apr 15, 2005 7:57 am
by polly
had mine welded twice before i got the shits and bout extractors and a 2 1/2 in system
extractors
Posted: Sun Apr 17, 2005 6:56 pm
by auntygranty
If you choose to go after market extractors pay atention to the clearance beside the sump .
Ive had sumps off xj's fitted with them and found a massive buld up of sludge/cabon where they ran too close
