Outer Limits 4x4 Board

Posted: **Sat Mar 26, 2005 6:14 pm**

hi all i looking for some help with sump bolts torque setting so i dont stuff the gasket and do i torque in down in 1 go or 2-3 stages some help would be great
Michael

Posted: **Sat Mar 26, 2005 6:29 pm**

start at the middle left looking from rear of sump and work like a head sequence tighten to 16 - 20 nm

DODGY DIAGRAM BUT HOPE YOU GET THE IDEA !!!!

Posted: **Sat Mar 26, 2005 6:31 pm**

mate the pic looks great

thanks

do you do it in stages ??
hammer

bilby wrote:start at the middle left looking from rear of sump and work like a head sequence tighten to 16 - 20 nm

DODGY DIAGRAM BUT HOPE YOU GET THE IDEA !!!!

Posted: **Sat Mar 26, 2005 6:34 pm**

H@MMeR wrote:mate the pic looks great thanks do you it in stages ??
hammer

bilby wrote:start at the middle left looking from rear of sump and work like a head sequence tighten to 16 - 20 nm

DODGY DIAGRAM BUT HOPE YOU GET THE IDEA !!!!

NOPE DODGY PAINT SHOP DIAGRAM
doesnt say anything bout stages for tightenin

reading outta the manual so it should be similar

hope it helps
cheers bill

Posted: **Sat Mar 26, 2005 6:44 pm**

bill it dose help thanks dude

bilby wrote:
H@MMeR wrote:mate the pic looks great thanks do you it in stages ??
hammer

bilby wrote:start at the middle left looking from rear of sump and work like a head sequence tighten to 16 - 20 nm

DODGY DIAGRAM BUT HOPE YOU GET THE IDEA !!!!

NOPE DODGY PAINT SHOP DIAGRAM
doesnt say anything bout stages for tightenin

reading outta the manual so it should be similar

hope it helps
cheers bill