Page 1 of 1
Gu Bullbar TD-6 to a 3.0Ltr
Posted: Sat Apr 02, 2005 1:20 pm
by GUJohnno
Does any one know wether the TD-6 ARB delux bullbar will bolt straight up to a 3.0Ltr Patrol. They are both series 3 and both built in the same year.
I'm thinking the bash plate underneath might be different.....
Posted: Sat Apr 02, 2005 1:34 pm
by Tubby
..........
Posted: Sat Apr 02, 2005 10:45 pm
by RoldIT
May or may not help but I am running an airbag factory nissan bar on a ute with out airbags so I dare say they are all pretty much the same, bolt-on wise.
Posted: Sun Apr 03, 2005 12:44 am
by bogged
RoldIT wrote:May or may not help but I am running an airbag factory nissan bar on a ute with out airbags so I dare say they are all pretty much the same, bolt-on wise.
the issue maybe that with the bigger radiator the mounts back there would be different?
Posted: Sun Apr 03, 2005 12:55 am
by RoldIT
I'd be surprised, they mount miles in front of the rad. Off the top of my head, 6-8" at least ...
Posted: Sun Apr 03, 2005 10:27 am
by InSanE
the fit fine we fit the same bar on 3.0L, 4.2L, and 4.8L Nissan Patrols there is no difference unless it is and airbag bar witch is just reinforced in different spots so it crumples on impact so airbags will go off
Posted: Mon Apr 04, 2005 9:22 pm
by GUJohnno
Thanks for the replies.
I swapped them over Sunday with out a hitch. The flimsy bash plate the comes with the TD-6 wasn't needed for the 3.0Ltr. Which was good as it was well and truely bashed.
I got $2,450 for the bar and 10,000Lb Warn winch, which I was pretty happy about. Enough for the FAT comp bar and body lift. Also picked up a high mount for $1300. Only used a few times.
Posted: Mon Apr 04, 2005 9:25 pm
by morkz
GUJohnno wrote:Thanks for the replies.
I swapped them over Sunday with out a hitch. The flimsy bash plate the comes with the TD-6 wasn't needed for the 3.0Ltr. Which was good as it was well and truely bashed.
I got $2,450 for the bar and 10,000Lb Warn winch, which I was pretty happy about. Enough for the FAT comp bar and body lift. Also picked up a high mount for $1300. Only used a few times.
what motor is on the high mount 4.6 or the old 2.5
Posted: Mon Apr 04, 2005 9:28 pm
by GUJohnno
not sure prob the old one
Posted: Tue Apr 05, 2005 12:20 pm
by turps
GUJohnno wrote:not sure prob the old one
Well if you do upgrade. put the 6hp one on not the 4.6 it is a bad design. Before the 6hp came out people where going back to the 2.5hp from the 4.6hp.
Posted: Thu Apr 07, 2005 6:45 pm
by GUJohnno
What would be the cost of a 6.0 Hp motor be...?
Posted: Thu Apr 07, 2005 7:37 pm
by sparky
$500-$600
Posted: Thu Apr 07, 2005 8:07 pm
by GUJohnno
damn.... shouldve gone for a discount...
