Page 1 of 1
Wheel studs
Posted: Thu Apr 14, 2005 3:17 pm
by nicbeer
Hey all
What is required in changing the wheel studs on the rear of the sierra. NT?
I have a new stud ready to go in.
thanks
Nic
Posted: Thu Apr 14, 2005 7:35 pm
by nicbeer
Someone must have replaced some of these before.
thanks
Posted: Thu Apr 14, 2005 7:39 pm
by roc box
take the drum off and knock the stud out and knock the new one in .
Posted: Thu Apr 14, 2005 7:46 pm
by nicbeer
Sweet, i thought it might be something like that.
thanks
Posted: Thu Apr 14, 2005 7:54 pm
by roc box
no problem
Posted: Fri Apr 15, 2005 2:56 am
by mtzook
Don't forget to line up the small splines before you knock it back in.
Posted: Fri Apr 15, 2005 4:04 pm
by roc box
good advice
Posted: Fri Apr 15, 2005 4:14 pm
by nicbeer
cheers mtzook. i will be doin this on suday.
I need to take the 4 nuts off and the philip head screws as well? to get the drum off.
I've never done the rear brakes only the front.
thanks
Posted: Fri Apr 15, 2005 4:24 pm
by roc box
make sure you back off the adjusters on drums before you remove them
Posted: Fri Apr 15, 2005 4:26 pm
by nicbeer
roc box wrote:make sure you back off the adjusters on drums before you remove them
Where are the adjusters when removing the drum? Do i need to remove the adjusters at all? or do mean this for the brakes only.
thanks
Posted: Fri Apr 15, 2005 4:41 pm
by OldGold
download the FSM nic and find out there!
Posted: Sun Apr 17, 2005 8:49 am
by roc box
theres a hole in the drum the adjusters are at about 5 + 7 oclock up is back off