Outer Limits 4x4 Board

hey anyone i need to no what thrust bearing carrier and thrustbearing you used in you holden 253/308 V8 conversion with the standart 5 speed manual also can you move the trust bearing up and down vertically and lastly what slave clinder did you use (those that have the 5 speed) thanx

What type of adaptor are you running ? and what type of gearbox is it ?

ok need to know a few more things. 1. model 2. gearbox 3. coversion kit used. mine is an 89 LN106 running a dellow conversion. was originally a 2.8 diesel with a G52 box. On mine the fork is a dellow made item and i believe its a holden v8 thrust bearing. spigot bush is dellow cast. slave cylinder is a 2.4 petrol one.
hope this helps a bit

that helps a little bit but do you no the part number of the slave cylinder and what sort of 2.4ltr petrol motor is it, my conversion is dellow, (privately brauoght) g52 gbox and its a ln65 was 2.4diesel

kegz wrote:that helps a little bit but do you no the part number of the slave cylinder and what sort of 2.4ltr petrol motor is it, my conversion is dellow, (privately brauoght) g52 gbox and its a ln65 was 2.4diesel

Is your bellhousing the proper hilux conversion one or the supra 5 speed one? The hilux one is usually a 360 degree bellhousing and the supra one is open at the bottom so you can fit a holden clutch cover.

best bet is to contact dellow engineering. Daisy St Revesby NSW. Tell them what youve got and theyll tell you what you need. They are a good bunch of blokes.

it is the proper 360 belhousing from dellow to g52 hilux

kegz wrote:it is the proper 360 belhousing from dellow to g52 hilux

Ok as the other fella said the toyota slave cylinder is the one you need. I have the supra bellhousing and run all holden gear, slave, master, throwout bearing etc.